Sensors Mechanical Oscillations (230 V, 50/60 Hz)

£ 233.28 (includes VAT at standard rate)

In stock

Free domestic shipping

Overview of all experiments in which the product is used

Ask a question

Description
Required
Recommended
Experiment

Product Information:_..

Set incorporating two dynamometers and an amplifier board for recording and analysing mechanical oscillations using a standard oscilloscope.
The dynamometers can be fitted to 10-mm diameter stands or a tie bar in order to measure dynamic forces along their axes.
The amplifier board converts signals from both dynamometers so that they can be recorded and also evaluates the phase differences between both oscillation signals, outputting them as a DC signal.
If the MEC amplifier board is connected to an USB oscilloscope, it is possible to perform detailed analysis and evaluation of measured signals using the oscilloscope software on a PC.

Specifications:_..

Dynamometers: _..
Maximum force:	5 N
Frequency range:	0.3 – 200 Hz
Connectors:	3.5 mm jack plugs
Dimensions:	52 mm x 37 mm x 26 mm₂
MEC amplifier board: _..
Input sockets:	3.5 mm jack sockets
Output sockets:	BNC
Dimensions:	65 mm x 100 mm x 40 mm

Contents:_..

2	Dynamometers
1	MEC amplifier board
1	Power supply, 12 V AC, 700 mA
2	Cables HF

Note:_..

This product allows for the digital visualization and analysis of a variety of experiments with different pendulum variants:₂

·	classic physical pendulum
·	reversing pendulum
·	coupled pendulums
·	String pendulum
·	Wilberforce pendulum.

The pendulum sets offered (see below) enable a cost-effective implementation of these pendulum experiments.