ACCESSORIES – TYPE S

Low voltage power supply with four outputs primarily intended to simultaneously supply power for the Teltron line of electron tubes and Helmholtz Coils, with four independent, adjustable DC voltages. more

The 0 – 500 V DC power supply is especially intended for operating electron tubes, including Helmholtz coils. The 0 – 500 V DC power supply provides four independently adjustable DC voltages. The DC voltages are stabilised ... more

Universally applicable, floating, high-voltage power supply with built-in, high voltage resistant transformer to supply the heater voltage for electron tubes. more

The 5 kV high voltage power supply is a universally usable non-earthed high voltage source for operating electron tubes. The 5 kV high voltage power supply provides a continuously variable stabilized high voltage with passive current ... more

The 0 – 20 V, 0 – 5 A DC power supply provides a DC voltage up to 20 V and a DC current up to 5 A. The output voltage and output current are continuously variable. The unit can be used either as a constant voltage source with ... more

The 0 – 20 V, 0 – 5 A DC power supply provides a DC voltage up to 20 V and a DC current up to 5 A. The output voltage and output current are continuously variable. The unit can be used either as a constant voltage source with ... more

The quantization of energy, as well as the generation, registration, and analysis of spectra and the associated experimental confirmation of models, are important components of most curricula around the world. The well-known 1913 experiment ... more

The quantization of energy, as well as the generation, registration, and analysis of spectra and the associated experimental confirmation of models, are important components of most curricula around the world. The well-known 1913 experiment ... more

Seventeen maximum-quality patch cords with 4-mm-connectors for all cabling between tubes, power supplies, display units and coils. Wire cross-section: 1 mm² Continuous current: max. 16 A Plug and jack: 4 mm Ø Quantity: 3 ... more

The tube holder accommodates the entire range of tubes model S designed for practical experiments, along with their accessories such as Helmholtz coils S (1000611) and an auxiliary coil (1000645), and can also serve as the base for the discharge ... more

The Helmholtz coils are used to create magnetic fields for deflecting electron beams and are attached to the tube holder S (1014525). The tube holder allows the coils to be set up in Helmholtz configuration or at varying distances. The resulting ... more

The quality of the electron beam in electron defraction tube S (1013889) is affected by the resistance between sockets C5 (cathode) and F4 (heating filament) on the tube. For optimum results, the resistance needs to be 390 kΩ. Tube holder ... more