Measurement Amplifier U
(115 V, 50/60 Hz)

More available in 2-10 days

Overview of all experiments in which the product is used

Ask a question

Description
Recommended
Experiments

Product Information:_..

Measurement amplifier U amplifies low-amplitude measurement signals from low-resistance signal sources for measurement with any chosen voltmeter or oscilloscope. By using an external shunt resistor it is also possible to measure small currents. Offset voltages can be compensated using coarse and fine offset adjustment knobs. Amplification (gain) can be selected in ranges from 0 to 5 powers of ten. High-frequency noise or other interference signals are filtered out by means of a low-pass filter with step-wise selectable time constants between 0 and 3 seconds. The output voltage has the same sign as the input voltage.

Specifications:_..

Mains voltage:	115 V ±10% (50/60 Hz)
Input resistance:	10 kΩ
Output resistance:	300 Ω
Offset voltage drift:	< 2 μV/K (after 15 mins. operation approx.)
Gain factors:	10⁰; 10¹; 10²; 10³; 10⁴; 10⁵
Tolerance for gain factors:	< 2.5 %
Input voltage:	max. ±12 V (overload protected for brief transients up to 100 V)
Output voltage:	0 … ±12 V (short-circuit protected)
Power supply:	12 V AC, (via plug-in supply provided)
Ambient temperature:	5°C - 23°C - 40°C
Storage temperature:	-20 - 70°C
Relative humidity:	< 85 % (no condensation)
Operational alignment:	horizontal
Contamination level:	2
Protection class:	IP20
Dimensions:	170 mm x 105 mm x 50 mm approx.
Weight:	335 g approx.

Measurement and frequency ranges (relative to 1 V output voltage):_..

Gain	Input voltage	Current through R_Shunt = 100 ohm	Frequency
10⁰	1 V	10 mA	0 … 25 kHz
10¹	100 mV	1 mA	0 … 25 kHz
10²	10 mV	100 µA	0 … 25 kHz
10³	1 mV	10 µA	0 … 20 kHz
10⁴	100 µV	1 µA	0 … 7 kHz
10⁵	10 µV	100 nA	0 … 7 kHz

Cut-off frequency for switchable low-pass filter:_..

Time constant	Cut-off frequency
0.0 s	See Table 1
0.1 s	1.6 Hz
0.3 s	0.5 Hz
1.0 s	0.16 Hz
3.0 s	0.05 Hz