ACCESSORIES - HALL EFFECT

The Differential Voltage sensor (1022539) is designed for measuring voltages in the range between -10 and +10 V. With a wide input voltage range this sensor can be used to measure voltages in AC and DC circuits. The sensor has differential ... more

Extra low-voltage power supply with overload protection contained in plastic housing. Output voltage has four switchable stages. Safety transformer conforming to EN 61558-2-6. Safe isolation between power supply and output circuits. ... more

Pair of pole pieces for experiments on the semiconductor Hall effect. Including clamping brackets for mounting on the U-core D (U8497215). Specifications: Pole shoe dimensions: 40x40x75 mm³ Total weight: approx. 2 kg more

U shaped core with no yoke for use with Transformer Core D items. more

Secondary coil for use with the U-core with Yoke (U8497180) to generate low- or high-voltage outputs. Coils are covered with impact resistant plastic so that they are safe to touch and use safety connection sockets. Specifications: ... more

Two-part holder accommodating sample boards and magnetic field sensor in experiments on the Hall effect. Samples and sensors are attached to the holder by means of fastening screws. more

Magnetic field sensor FW ± 2000 mT is used to measure magnetic flux density in the tangential direction. Located on the tip of the probe is a Hall sensor with an output signal proportional to the operating voltage. The sensor is equipped ... more

The Voltage sensor BT32i is designed for measuring voltages between -500 and +500 mV. The sensor has diff erential inputs; measurements can be done directly across circuit elements without the constraints of common grounding. It has two ... more